156Single Liner High Tack Media Blast Stencil - Machine Cut

High quality, durable stencil coated with an advanced, high tack, water-based, pressure sensitive acrylic adhesive protected by a clear polyester liner. Contains a slot-hole pattern. Rubber is trimmed back ½” along each edge for IBM® cutters. #156 is designed and recommended for raw / unfinished wood, HDU foam-board, brick, and rough stone. Replaces #125 stencil and is not intended for use on polished or painted surfaces.
Technical Data Sheet Article Document

Key Features

Aggressive acrylic adhesive may transfer to pre-treated or painted surface and/or may lift the grain of wood (esp. soft woods). Remove immediately after blasting whenever possible. #156 will not work on Gerber® 30” plotter (Recommend #116 for this machine).