Filter By
Products
Page 2 of 20
-
156
High quality, durable stencil coated with an advanced, high tack, water-based, pressure sensitive acrylic adhesive protected by a clear polyester liner. Contains a slot-hole pattern. Rubber is trimmed back ½” along each edge for IBM® cutters. #156 is designed and recommended for raw / unfinished wood, HDU foam-board, brick, and...
View Product -
157
High quality, durable stencil coated with an advanced, medium tack, rubber-based pressure-sensitive adhesive protected by a clear PET liner. Half inch on center hole pattern designed for IBM® sprockets. Tractor-feed holes are punched through liner and rubber. The specially treated polyester liner retains cut designs during transfer from plotter to...
View Product -
197
A utility grade, economically priced, MOPP strapping tape that is designed to work in most unitizing and palletizing applications. The synthetic rubber adhesive offers excellent long lasting bond and shear adhesion to a variety of surfaces.
View Product -
199
1.0 mil polypropylene film with economical fiberglass reinforcements and a 'solventless' pressure-sensitive synthetic rubber/resin adhesive. Provides excellent adhesion to corrugated cartons and outstanding holding power.
View Product -
211 FILLER
211 stencil filler is specially formulated to work with most stencil products’ adhesive and create a better bond to the substrate during sandblasting. This extra bond helps small, intricate designs to stay attached to the substrate and not lift when sandblasting pressure is applied. 211 filler is a formulated high...
View Product -
2188
Uni-directional polyester (PET) filament strapping tape with a pressure-sensitive synthetic rubber adhesive. Offers medium tensile strength, high adhesion and excellent impact strength.
View Product -
223 FILLER
223 stencil filler is specially formulated to work with the most stencil products’ adhesive and create a better bond to the substrate during sandblasting. This extra bond helps small, intricate designs to stay attached to the substrate and not lift when sandblasting pressure is applied. 223 filler is a formulated...
View Product -
333 FILLER
333 stencil filler is specially formulated to work with all IPG ‘Anchor’ stencil products’ adhesive to create a better bond to the substrate during sandblasting. This extra bond helps small, intricate designs to stay attached to the substrate to prevent lifting when sandblasting pressure is applied.
View Product -
4118
Kapton® polyimide backing and silicone adhesive offers outstanding thermal resistance and excellent electrical insulating properties. This tape is used where toughness, puncture resistance, extreme resistance to heat, and flame retardance are required. Operating temperature range is -60°C (-76°F) to +260°C (500°F).
View Product -
4237
High tensile strength glass filaments and conformable PET film coating with an aggressive adhesive for a variety of heavy duty insulating, banding and holding applications. The 1.0 mil polyester film provides puncture, edge tear and abrasion resistance. 4237 is specially designed and intended for use in oil filled transformers. Once...
View Product -
4238
Polyester film provides puncture resistance, abrasion resistance and resistance to edge tear. High tensile strength, conformable backing with aggressive adhesive for a variety of heavy duty insulating and holding applications. Very resistant to chemicals, solvents and aging, and offers excellent dielectric strength and insulation resistance.
View Product -
4426
Puncture resistant polyester film/rope fiber laminated backing and aggressive rubber adhesive make this a low cost all-purpose, electrical insulating tape. Rubber thermosetting adhesive system gives excellent solvent resistance.
View Product
